• 11-04-2010, 23:30:03
    #10
    usta neden bios güncellemesi yapıyorsun ? öğrenebilir miyim?
  • 12-04-2010, 19:45:21
    #11
    Eposta Aktivasyonu Gerekmekte
    award bootblock bios v1.0

    bios rom checksum error
    detecting floppy drive a media...
    driver a error. system halt


    şeklinde hata veriyor ve sürekli kesik kesik bip bip bip ötüyor


    nasıl olduysa pc acıldı üzerindeki bios ga-8st800 f3 gigabyte bios uptade programı üle online olarak güncelledim biosu ve yine aynı hata.
  • 13-04-2010, 20:18:00
    #12
    Eposta Aktivasyonu Gerekmekte
    gigabyte gelen cvp

    Dear altan ,

    We are not sure what steps you have tried. If not yet tried to clear CMOS, please do so. Please kindly clear CMOS first. You can take off the on-board battery to leak voltage to clear CMOS. Please follow the steps below. Thank you.

    1) Turn off power.
    2) Remove the power cord from MB.
    3) Take out the battery gently and put it aside for about 10 minutes or longer. (Or you can use a metal object to connect the two pins in the battery holder to make them short-circuited.)
    4) Re-insert the battery to the battery holder.
    5) Connect power cord to MB again and turn on power.
    6) Press F1 to enter BIOS and load fail-safe defaults setting.
    7) Save changes and reboots the system.

    However, if system boot failed, probably there’s something wrong with the hardware. Please contact your supplier or our distributors/resellers in your area for repair.

    Best Regards,
    GIGABYTE TECHNOLOGY
  • 20-04-2010, 21:43:02
    #13
    Üyeliği durduruldu
    Biosunda hata var hala... Çok eskiden serviste çalışırken benzer hata ile gelen bir p3 bilgisayarda ana kartın gücünü kesip pilini çıkarttıktan sonra pil yuvasındaki + - bağlantıları birleştirip 1 dk bekleyerek anakarttaki tüm gücün boşalarak belleklerin temizlenmesini sağlamıştık tekrar açtıgımızda düzelmişti. Dene istersen bir zamarı yok sadece bios saatini sıfırlıyor. Sana gelen cevaptada aynısını önermiş zaten 1 dakika yerine 10dk veya daha fazla tutman söylenmiş olmazsa bir yetkiliye göstermen bildirilmiş.

    altan1907 adlı üyeden alıntı: mesajı görüntüle
    gigabyte gelen cvp

    Dear altan ,

    We are not sure what steps you have tried. If not yet tried to clear CMOS, please do so. Please kindly clear CMOS first. You can take off the on-board battery to leak voltage to clear CMOS. Please follow the steps below. Thank you.

    1) Turn off power.
    2) Remove the power cord from MB.
    3) Take out the battery gently and put it aside for about 10 minutes or longer. (Or you can use a metal object to connect the two pins in the battery holder to make them short-circuited.)
    4) Re-insert the battery to the battery holder.
    5) Connect power cord to MB again and turn on power.
    6) Press F1 to enter BIOS and load fail-safe defaults setting.
    7) Save changes and reboots the system.

    However, if system boot failed, probably there’s something wrong with the hardware. Please contact your supplier or our distributors/resellers in your area for repair.

    Best Regards,
    GIGABYTE TECHNOLOGY